![]() ![]() Only Environmental Footprint indicator ( mid-point ) shows up. The LCIA default "Okobaudat", does not show up after Okobaudat installation, like in the manual says, in the Indicators and Parameters, Impact assessment metods,tab. ![]() ![]() I am sying this also, because, after calculation, when I change the quantities of the flows/materials, I save, and I calculate again, I do not see any changes in the results. Or is there a problem with the quantities of flows/materials? I have an output of 91.4 t and input of 100.4 tons aprox., does it make sense? Actually, 91.4 t It is the same value I put in Product Systems, General Information, Reference, Target Amount 91.4 Unit t. Should not be "system process" instead? or in the case of Okobaudat is different? Hi, I have found the info in the documents of Okobaudat manual open lca, page 17, cradle to grave, but I still do not understand, why it is recommended "unit process" modeling and validation, when I want to calculate the whole life cycle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |